Polycom Vortex EF2210 - Page 44

Q01DELAYOEB0
Disable output delay on output
B .
Q01DELAYOEB0
Q01DELAYOEB0
Toggle enabled status of output
delay on output B .
Q01DELAYOEBx , where x is either 0 or 1
depending on the current enabled status of the
output delay on the output.
Q01DELAYOEB?
Query enabled status of output
delay on output B .
Q01DELAYOEBx , where x is either 0 or 1
depending on the current enabled status of the
output delay on the output.
Q01DELAYOE*1
Enable output delay on all
outputs (1, A, B) .
Q01DELAYOE*111
Q01DELAYOE*0
Disable output delay on all
outputs (1, A, B) .
Q01DELAYOE*000
Q01DELAYOE*010
Enable output delay on output
A, and disable output delay on
outputs 1 and B.
Q01DELAYOE*010
Q01DELAYOE*2
Toggle enabled status of output
delay on all outputs.
Q01DELAYOE*abc , where each of the letters
(a, b, etc.) is either 0 or 1 depending of the
current enabled status of the output delay on
the corresponding output. If this command
was sent after the example above, then the
status message would be Q01DELAYOE*101 .
Q01DELAYOE*?
Query enabled status of output
delay on all outputs.
Q01DELAYOE*abc , where each of the letters
(a, b, etc.) is either 0 or 1 depending of the
current enabled status of the output delay on
the corresponding output. If this command
was sent after the example above, then the
status message would be Q01DELAYOE*101 .
8.39. DSPAUTO -- Enable Automatic DSPLOAD Status
Messages
This command sets or queries whether or not DSPLOAD messages will be automatically generated
whenever the DSP utilization changes.
This command is a boolean command. See
Section 6.1 for more information on this type of
command.
Example Description Status Message
Q01DSPAUTO1
Enable automatic DSPLOAD messages.
Q01DSPAUTO1
Q01DSPAUTO0
Disable automatic DSPLOAD
messages.
Q01DSPAUTO0