THE ART OF WELDING
P6 HW
2-100 PN-0110008 Rev. 12
Document revision
Rev. 0 Original 02/2011
Rev. 1 Update
“Start cycle with restart” 09/2011
Rev. 2 Update "Option commands mechanised equipmen" 11/2011
Rev. 3
Update: FNCA 1201-039 and FNCA 1201-019 – Items on pages 56, 57, 58 und 59
– minimal gas values on page 19, "Rear connector panel" on page 39.
02/2012
Rev. 4
Addition of chapters: Connecting the measuring unit, Adjusting the measuring card,
Compatibility of standard equipment.
Changes to pictures of the P6 power source.
Update : Error and codes processing
03/2012
Rev.5
Updated after FNC 1206-031 (reference card source changes and corrections of
translation)
06/2012
Rev. 6
Addition adapter manual torch.
10/2012
Rev. 7
Addition "Settings oxygen meter confi guration" "IP Address", updates chapters
"Making adjustments during a weld cycle" and "Error and codes processing"
11/2012
Rev. 8 Modifi cation touchscreen controller, addition chapter remotes control on board 03/2013
Rev. 9 Addition manual torch adapter 0023000901 04/2013
Rev. 10 Using the remote control to regulate the AVC 10/2013
Rev. 11 Update touchscreen (09/2013) 02/2014
Rev. 12 Aktualisierung : " Servicing" 08/2014
If this technical manual is to be printed, both sides of the page must be used to improve under-
standing and readability.
This manual must be delivered to users.
Product
Reference
Manual
Redactor
P6 HW mobile power source
0025069101
PN-0110008
SBR
To Next Page
Loading...
