THE ART OF WELDING
P6 HW
20-100 PN-0110008 Rev. 12
The P6 HW version remote control3. 3. 2.
This remote control controls and adapts all functions
and settings remotely:
Positioning welding heads and wire feeders.•
Starting and stopping weld cycles.•
Starting and suspension of the “hot wire” cur-•
rent.
Selecting WPs and programs.•
Simulating weld programs.•
Minor modifi cations during a weld cycle.•
Shielding gas test.•
Manual starting of the cooling pump(s) and the •
gas(es).
Fig. 3.12 - Remote control - version P6 HW
To Next Page
Loading...
