Polysoude P6 HW - Torch Cooler Connections; Fig. 4.6 - Connection of External Coolant to the P6 HW

THE ART OF WELDING
P6 HW
21
28-100 PN-0110008 Rev. 12
Torch cooler connections4. 2. 6.
The P6 HW must be connected to an external cooler. The connection to a wastewater system or external cooling system
is at the rear of the power source.
Fig. 4.6 - 1 "Water" inlet
Fig. 4.6 - 2 "Water" return
The direction in which the coolant travels must be correct as the fl ow rate is controlled by a safety system inter-
nal to the P6 HW.
Fig. 4.6 - Connection of external coolant to the P6 HW