Polysoude P6 HW - Table of Illustrations

THE ART OF WELDING
P6 HW
PN-0110008 Rev. 12 95-100
Table of illustrations
Fig. 3.1 - P4 power source ................................................................................................. 13
Fig. 3.2 - P6 power source ................................................................................................. 13
Fig. 3.3 - P6 HW power source ........................................................................................... 12
Fig. 3.4 - MU IV welding head ............................................................................................ 16
Fig. 3.5 - Polycar welding carriage ...................................................................................... 16
Fig. 3.6 - MW welding head ................................................................................................ 16
Fig. 3.7 - TS 34 welding head ............................................................................................. 17
Fig. 3.8 - TS 2000 welding head ......................................................................................... 17
Fig. 3.9 - TS 8/75 welding head .......................................................................................... 17
Fig. 3.10 - Polyfi l-3 wire feeder .......................................................................................... 17
Fig. 3.11 - Description of the P6 HW power source ................................................................ 19
Fig. 3.12 - Remote control - version P6 HW .......................................................................... 20
Fig. 4.1 - P6 HW power source accessories ........................................................................... 22
Fig. 4.2 - P6 HW rating plate .............................................................................................. 23
Fig. 4.3 - Connecting the gas supply to the P6 HW ................................................................ 25
Fig. 4.4 - Connection diagram if one gas is used ................................................................... 25
Fig. 4.5 - Connection diagram if two different gases are used ................................................. 25
Fig. 4.6 - Connection of external coolant to the P6 HW .......................................................... 28
Fig. 4.8 - Connection of the remote control unit to the P6 HW power source ............................. 31
Fig. 4.9 - Connection of an open welding head of the MU type or a tube/tube sheet welding
head of the type TS or TP ................................................................................ 33
Fig. 4.10 - Connection of a “Polycar hot wire” type head ....................................................... 35
Fig. 4.11 - Connection of a gas cooled closed chamber welding head ....................................... 36
Fig. 4.12 - Connection of a liquid cooled closed chamber welding head with integrated com-
mand buttons ................................................................................................ 37
Fig. 4.13 - Connection of a wire feed unit............................................................................. 38
Fig. 4.14 - Connection of a closed chamber welding head equipped with tacheometry ................ 39
Fig. 4.15 - Connection of a manual torch ............................................................................ 40
Fig. 4.16 - Rear panel of the power source and oxygen meter ................................................. 42
Fig. 4.17 - Power source rear connection panel .................................................................... 43
Fig. 4.18 - Modules .......................................................................................................... 43