Polysoude P6 HW

To Next Page

To Previous Page

THE ART OF WELDING

P6 HW

96-100 PN-0110008 Rev. 12

Fig. 4.19 - Ethernet switch and power supply ...................................................................... 43

Fig. 4.20 - Remote control unit with emergency stop ............................................................. 44

Fig. 4.21 - Connector wiring ............................................................................................... 45

Fig. 4.22 - Front connector panel ....................................................................................... 47

Fig. 4.23 - Rear connector panel ......................................................................................... 49

Fig. 4.24 - Remote control - version P6 HW .......................................................................... 51

Fig. 5.1 - Controls used for positioning the electrode ............................................................. 56

Fig. 5.2 - Controls used for positioning the ﬁ ller wire ............................................................. 56

Fig. 5.3 - Controls used for adjusting the oscillation .............................................................. 57

Fig. 5.4 - Push button for testing gas - testing coolant - and restarting the coolant pump ........... 57

Fig. 5.5 - Controls used for selecting the WP/program ........................................................... 58

Fig. 5.6 - “Simulation / With Arc” indicator lights .................................................................. 58

Fig. 5.7 - Pushbutton to control cycle start ........................................................................... 58

Fig. 5.8 - Pushbutton for tuning during the cycle ................................................................... 58

Fig. 5.9 - “Override” buttons for developing programs ........................................................... 59

Fig. 5.10 - Reprint ticket for weld carried out ........................................................................ 59

Fig. 5.11 - Pushbutton to command stoppage with slope down .............................................. 60

Fig. 5.12 - Pushbutton to command immediate stoppage ...................................................... 60

Fig. 5.13 - Polysoude USB key ............................................................................................ 60

Fig. 5.14 - Push button start cycle with restart ..................................................................... 60

Fig. 6.1 - Position of settings for the source interface card 0028029400 ................................... 62

Fig. 6.2 - Position of settings for the source interface card 0028029200 ................................... 64

Fig. 6.3 - Position of settings for the arc voltage measurement card 0028079100 ...................... 65

Fig. 6.4 - Measuring card 0028059100 ............................................................................... 67

Fig. 6.4 - Printers ............................................................................................................. 69

Fig. 6.5 - Location of fuses FU1, FU2 and FU3 ....................................................................... 70

Fig. 6.6 - Location of fuse FU4 ............................................................................................ 70

Fig. 6.7 - Coolant ﬁ lter ...................................................................................................... 70

Fig. 6.8 - Connector for USB key ........................................................................................ 75

Fig. 6.9 - Internal right-hand view ...................................................................................... 76

Fig. 6.10 - Internal left-hand view ...................................................................................... 76

Fig. 6.11 - Internal view from above ................................................................................... 76

Polysoude P6 HW - Page 96