5-55
Programming Overview
LEARN
LEARNi.e., module, sensor or P-Link
device)
panel conguration software
system. (Please refer to “Panel Software Overview” and “Mapping Zones” in this section for details on these procedures.)
The Programming Cycle
1.
2.
Run LEARN3.
4.
5.
6.
7.
Note
Software Installation
i.e., right click to display short cut menus, drag and drop, etc.
“System Programming
Note
To install the software:
y www.pottersignal.com"Fire Alarm Systems" link, "Fire Panel
Conguration Software" icon
y C:\ProgramFiles\Potter\Pottter Fire Panel Programmer.
y