3-24
Addressing SLC Devices
hand-held address setting device System Tools – SLC Addr Prog option. Only
i.e., #1-15, 50-75, and 100-127) as necessary.
To address devices via a hand-held address device:
1.
2. Enter
3.
NotePower
To address devices from the Panel:
Press 1. ENTERMain Menu.
Press2. 5 to access System Tools5=System Tools).
Pressy ENTER“Enter Code” prompt
y
Note**** (asterisks
y System Tools menu
Press 3. 1 to select SLC Tools.
Press 4. 3 to select SLC Addr Prog “Enter key will Shutdown System”
Press 5. ENTERESCSLC Addr Prog).
SLC Addr Prog menu
3=SLC Addr Prog
SLC PGM terminals (as shown below).
Example of Control Panel Showing SLC Program Terminal Figure 22.
Main Menu
5=System Tools
1=SLC Tools
3=SLC Addr Prog
DWG #602-3B
SLC Program Terminals
To Next Page
Loading...
