Power Electronics SD300 Series - Page 215

POWER ELECTRONICS
SD300
DESCRIPTION OF PROGRAMMING PARAMETERS
213
Screen
Description
Default
value
Range
Function
Set on
RUN
Note: Comes from the previous page.
OPT.
DESCR.
FUNCTION
10
COMPARE
- GT
Comparison operation: if
(A > B) the output is C; if
(A </=B) the output is 0.
If C is not configured
(default value 0x0000),
the output when the
condition is satisfied is 1.
11
COMPARE
- GEQ
Comparison operation; if
(A >/= B) output is C; if
(A<B) the output is 0.
If C is not configured
(default value 0x0000),
the output when the
condition is satisfied is 1.
12
COMPARE
-EQUAL
Comparison operation, if
(A == B) then the output
is C. Otherwise, the
output is 0.
If C is not configured
(default value 0x0000),
the output when the
condition is satisfied is 1.
13
COMPARE
-NEQUAL
Comparison operation, if
(A!= B) then the output is
C. Otherwise, the output
is 0.
If C is not configured
(default value 0x0000),
the output when the
condition is satisfied is 1.
Note: Continues on the next page.