■ 4 Modes of operation and operating
22
4 Modes of operation and operating
4.1 Switching on the balance
•Press «ON/OFF» to switch on the balance.
The balance carries out a self-diagnosis in order to check the most im-
portant functions. After completion of the start-up process (approxi-
mately ten seconds) “Zero” appears in the display.
The balance is ready for operation and is in the weighing mode.
4.2 Auto-Standby Mode
The balance is equipped with an Auto-Standby mode, which can be
activated or deactivated in the configuration menu.
If the Auto-Standby mode is activated, the balance automatically
switches to Standby some time after the last weighing or key opera-
tion (current-saving function).
The delay before switching to Standby is defined in the configuration
menu (see Chapter 5.7 “Weighing mode”).
• Press any button or put on a weight in order to switch the balance
from the Standby mode back to the weighing mode again.
4.3 Significance of the two main menus
The balance has two main menus available: the configuration menu
and the application menu.
The basic-program of the balance is defined in the configuration
menu. With this, you can either work with the basic-configuration pro-
grammed ex-works, or define and store a user-configuration adapted
to your specific needs.
In the application menu, you define a working program, which is
suited to the specific weighing problem.
In addition, you also define the parameters for the statistics program
and the check-Reference weighing in the application menu.
To Next Page
Loading...
