Precisa Series XT - Set Weighing Mode: Auto-Standby; Set Weighing Mode: Auto-Zero; Notes on Calibration

■ 14 Further information
80
14.1.3 Set Weighing mode: Auto-Standby
The Auto-Standby mode turns off the balance automatically, if:
• the balance is tared and has shown “Zero” for at least 5 minutes
• the balance has received no remote control command via the inter-
face for at least 5 minutes,
• the automatic zero correction “Auto-Zero” is activated.
It is possible to start the balance again after it has been switched off
by an automatic Auto-Standby:
• Briefly depress any key
• Put a weight on the scale
• Give a remote control command via the interface
14.1.4 Set Weighing mode: Auto-Zero
If the automatic zero correction “Auto-Zero” is activated, the balance
always gives a stable zero (e.g. even with room temperature fluctua-
tions).
14.2 Notes on calibration
The calibration of the balance is fixed in the Configuration menu (see
Chapter 3.7 “Calibration of the balance” and Chapter 5.6 “Calibration
functions”).
Possible types of calibration, depending on the model of balance:
• External calibration by means of ICM (Intelligent Calibration Mode)
• External calibration with freely selectable weight
• Internal calibration
• Automatic calibration
NOTE
The calibration can be interrupted at any time by pressing
«ON/OFF».