4 Modes of operation and operating ■
29
4.6 Password protection of the menus
The two main menus of the balance can be protected by a freely
selectable, four-figure password against unintentional changes.
• With password protection deactivated, any operator can change the
balance configuration and application menus.
• With “med” password protection activated, only the configuration
menu is protected against unintentional changes.
• With “high” password protection activated, both the configuration
menu and the application menu are protected against unintentional
changes. Only after entering the correct, four-figure password can
changes be made to the configuration menu and the application
menu.
For the activation of the password protection and changing the pass-
word, see Chapter 5.10 “Password protection”.
4.7 Anti-theft encoding
The balance can be protected against theft by a freely selectable,
four-figure numerical code:
• With anti-theft encoding deactivated, the balance can be switched
on again and operated after interruption of the power supply
without entering a code.
• With anti-theft encoding activated, the balance requires the entry of
the four-figure code after each interruption to the power supply.
• If the code is input incorrectly, the balance is blocked.
NOTE
The password protection is deactivated at the works.
The pre-programed password set in the works is: 7 9 1 4
This password is the same for all Precisa balances and is always
valid, in parallel with a self-selected password.
Make a note of your personal password.
To Next Page
Loading...
