Precisa Series XT - Page 37

5 Working with the Configuration menu ■
35
With “SET PRINTFORMAT”, elements which are switched on are prin-
ted in each case:
• With “UNITS” all momentarily active units are printed out,
• with “PRODUCT ttt...” the product name can be entered alphanu-
merically,
• with “PRODUCTMODE HOLD” this product name is stored,
• with “PRODUCTMODE DELETE” it is deleted after each expression,
• with “PRODUCTMODE COUNT” a counter, which is incremented by
1 after each expression,
• “OPERATOR ttt...” is the alphanumeric input of the operator.
When a peripheral device (for example a printer) is connected, the
balance interface must be configured in the submenu “SET INTER-
FACE” (see Chapter 5.8 “Interface-functions”).
SET PRINTFORMAT DATE AND TIME ON/OFF
BALANCE-ID ON/OFF
PRODUCT-ID ON/OFF
GROSS AND TARE ON/OFF
UNITS ON/OFF
OPERATOR-ID ON/OFF
LINEFEED OFF/1/../FORMFEED
PRODUCT ttt...
PRODUCTMODE HOLD
PRODUCTMODE DELETE
PRODUCTMODE COUNT
OPERATOR ttt...
Menu continued on following page.