SAFETY SUMMARY
The following general safety precautions must be observed during all phases of op-
eration, service, and repair of this product. Failure to comply with these precautions
or specific WARNINGS given elsewhere in this manual will violate safety standards of
design, manufacture, and intended use of the product.
Preen assumes no liability for the customer‘s failure to comply with these require-
ments.
1) BEFORE APPLYING POWER
Verify that the product is set to match with the power line input.
2) PROTECTIVE GROUNDING
Make sure to connect the product to the protective ground to prevent an elec-
tric shock before turning on the power.
3) NECESSITY OF PROTECTIVE GROUNDING
Never cut off the internal or external protective grounding wire, or disconnect
the wiring of protective grounding terminal. Doing so will cause a potential
shock hazard that may bring injury to a person.
4) DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the product in the presence of flammable gases or fumes.
5) DO NOT REMOVE THE COVER OF THE PRODUCT
Personnel who operate the product must not remove the cover of the product.
Component replacement and internal adjustment can be done only by qualified
service personnel.
LETHAL VOLTAGES. The product can supply 440V peak at its output. DEATH on
contact may result if either the output terminals or the output circuits connected
to the output are touched when the product output is on.
To Next Page
Loading...
