OTHER FEATURES
7. Symbol for remote control
8. Weekday/program day
9. Current time/program time
10. Temperature display
11. Status display
When the power supply has been connected, all
the elements in the display flash -the time must
be set. Heating cannot start until the time is set.
Setting Time and Weekday for the First Time
Briefly press (1). The time display 12:00 flashes.
Set the current time using (4) or (5). When the
time display stops flashing, the time has been
stored.
The weekday begins to flash. Set the current
weekday using (4) or (5). When the weekday
stops flashing, the weekday has been stored.
If the ignition is “ON”, the display continues to be
displayed.
If the ignition is “OFF”, the display disappears
after 10 seconds.
Changing Time and Weekday
Press and hold (1) until the time flashes.
Proceed as per instructions for setting time and
day for the first time.
If only the time is to be set, you may skip setting
the weekday by pressing (1) twice.
When the weekday has been set, press (1) to
stop the display from flashing and to store the
time and day.
Heating Without Programming (Ignition
“Off”)
Press (3). The status display (11) will show
heating symbol.
The default heating time is set to 120 minutes. It
can be changed temporarily or permanently.
Temporarily Setting Heating Time
With heater on, press (4) to decrease time
(minimum 1 minute) or (5) to increase time
(maximum 120 minutes).
Permanently Setting Heating Time
With heater “OFF” (do not press (3), press and
hold (4) (approx. 3 seconds), until display
appears and flashes.
Set heating time (from 10 to 120 minutes) using
(4) or (5).
When display disappears, the new heating time
has been stored.
Switching Off Heating
Briefly press (3).
The heating symbol will disappear from status
display (11).
System switches to automatic after-run for
cooling.
Heating Without Programming (Ignition “On’)
To switch heating “ON”, press (3). The status
display (11) will show heating symbol, as well as
time and weekday.
Heating will remain “ON” until ignition is switched
“OFF”.
If the ignition is switched “OFF”, the heater
remains switched on for 15 minutes.
This time can be increased (max. 120 minutes)
by pressing (5) or decreased (min. 1 minute) by
pressing (4).
Switching Off Heating
Briefly press (3).
The heating symbol will disappear from status
display (11).
System switches to automatic after-run for
cooling.
Programming Start Of Heating
3 switch-on times within the following 24 hours or
one switch-on time in 7 days can be
programmed. Only one switch-on time can be
activated at one time.
Selecting and activating memory:
(starting from neutral status with display visible)
First memory – press (2) once.
Memory display: 1 (default time setting 12:00)
Second memory – press (2) twice.
Memory display: 2 (default time setting 12:00)
Third memory – press (2) three times.
Memory display: 3 (default time setting 12:00)
Neutral status (no memory activated) – press (2)
repeatedly until memory display disappears.
66
To Next Page
Loading...
