PREVOST H3-45 - 4-Point Securement with Anchorage to Passengers Seat Pedestals

5-50 Other Features
PA-1628Operator's ManualH3-45 COACH
Release the anchor by lifting the lock pin then sliding
out and up the anchor from the floor pocket. Close
the lid to prevent dirt from entering the pocket cavity.
WARNING
Do not let restraint belts or occupant safety belts
rub against sharp edges. Do not bleach or dry
clean.
Wheelchair Occupant Restraint
Secure the wheelchair occupant in the following
manner:
Fix the lap belt to the pins on the retractors of the rear
restraint belts. Adjust the lap belt so it sits snug
across the hips. Make sure that you place the lap
belt buckle on the center aisle side. Fasten the
shoulder belt to the pin on the lap belt buckle. A
retractor adjusts shoulder belt length automatically.
WARNING
A snug fit with the lap belt positioned low on the
hips is necessary to maximize safety. The belt
should not be worn or twisted. Avoid pinching the
belt and/or hardware. Do not wear over rigid or
breakable objects such as eyeglasses, pens or
keys as these may cause injuries.
CAUTION
The safety belt buckle provided with the red
release button must always be located on the
center aisle side.
To release the belts, unfasten the shoulder belt then
press the red release button found on the lap belt
buckle.
4-POINT SECUREMENT WITH ANCHORAGE
TO PASSENGERS SEAT PEDESTALS
This securement system includes:
l 4 wheelchair restraint belts and retractors
with anchorage to passengers seat
pedestals.
l Occupant securements: lap and shoulder
belt.
WHEELCHAIR AND OCCUPANT RESTRAINT SYSTEM
To secure the wheelchair, four restraint belts must
be used (at all four corners). Hook one wheelchair
restraint belt to each corner of the wheelchair frame
(not the wheels) and allow the retractors to tension
the belts.
To remove the restraint belts, push down on the
tension release lever found on the retractor. Unhook
the wheelchair and allow the belts to retract. Guide
the belts in, making sure they remain untwisted as
they retract.
Wheelchair Occupant Restraint
Secure the wheelchair occupant in the following
manner:
Fasten and adjust the lap belts so it sits snug across
the hips. Make sure that you place the lap belt buckle
on the center aisle side. Fasten the shoulder belt by
inserting the lap belt tab into the shoulder belt buckle.
A retractor adjusts shoulder belt length
automatically.
WARNING
A snug fit with the lap belt positioned low on the
hips is necessary to maximize safety. The belt
should not be worn or twisted. Avoid pinching the
belt and/or hardware. Do not wear over rigid or
breakable objects such as eyeglasses, pens or
keys as these may cause injuries.
CAUTION
The safety belt buckle provided with the red
release button must always be located on the cen-
ter aisle side.
To unfasten the belts, press the red release button
on the shoulder belt buckle first and then unfasten
the lap belt by pressing the red release button on the
lap belt buckle.