Section 16: SUSPENSION
PA1593
20
3.4 TORQUE SPECIFICATIONS
The following table lists the tightening torque for
fasteners requiring a specific torque value.
When no torque specifications are indicated, use
the Standard Torque Specifications table found
in Section 00: General Information of the
Maintenance Manual.
SPECIFIC TORQUE TABLE 2 – REAR SUSPENSION
DESCRIPTION QTY
TORQUE DRY (lbf-ft / Nm)
Radius Rod Stud 2 20-40 27-54
Radius Rod Retaining Nut or Bolt 2 110-130 150-175
Radius Rod Support Nut 4 110-130 150-175
Sway Bar Link Upper Nuts 2 99-121 134-164
Sway Bar Link Lower Nuts 2 80-100 108-136
Shock Absorber Support 4 145-165 196-224
Air Spring Lower Nut 4 20-25 27-34
Air Spring Upper Nut 2 20-25 27-34
* Tighten nut to specified torque, then advance to next aligning cotter pin slot and install a new cotter pin.
To Next Page
Loading...
