Section 01: ENGINE
PA1593
10
1.3.10 Oil Filters Change
WARNING
Hot oil can cause severe burns. DO NOT
allow hot oil to contact the skin. When
changing oil, wear protective gloves.
CAUTION
Volvo-branded oil filters are designed to
provide the proper level of filtration and
protection for Volvo engines. Filters that do
not meet the same stringent requirements
may cause unsatisfactory results.
Clean around the oil filter housing and
remove the filters using the oil filter
wrench or the oil filter socket.
FIGURE 5: OIL FILTER WRENCH
Prefill the new oil filters with approved
engine oil. Also, lubricate the filter gaskets
with engine oil (1). Hand tighten the oil
filters until they contact the sealing surface
of the oil filter housing (2). Manually
tighten the oil filters an additional ¾ to 1
full turn (3).
FIGURE 6: OIL FITER REPLACEMENT
Start the engine and check for leaks
around the oil filter housing and filters.
Check the oil level. Add approved engine
oil to the recommended level, if
necessary. Do not overfill.
To Next Page
Loading...
