Section 00: GENERAL INFORMATION
5
PA1593
Also the engine data plate certifies that the
engine conforms to federal and any state
exhaust emissions regulations.
4.1.2 Transmission
The transmission identification plate is located
on the oil level dipstick side of the transmission
(WT) (Fig. 2). The identification plate shows the
transmission serial number, part number
(assembly number), and model number. Use all
three numbers when ordering parts.
FIGURE 2: ALLISON TRANSMISSION 07076
4.1.3 Drive Axle
FIGURE 3: TYPICAL SERIAL & MODEL NUMBERS 00007
4.1.4 Front Axle
FIGURE 4: I-BEAM AXLE TYPICAL SERIAL & MODEL
NUMBERS
00008
4.1.5 Power Steering Pump
Power steering pump is mounted on the engine
and located underneath the air compressor (Fig.
5).
FIGURE 5: POWER STEERING PUMP
4.1.6 Coach Final Record
The Coach Final Record is a record of all data
pertaining to the assembly of the vehicle. This
record is shipped to the new customer via a
courier company. Retain this record in the
company records office for reference and safe-
keeping.
4.1.7 Safety Certification
Vehicle components meet specifications and
standards as follows:
- Material and parts conform to ASTM and/or
SAE standards in effect at the time of
manufacture.
- All factory-installed interior materials meet
FMVSS 302 for fire resistance.
- Certified according to Provincial, State and
Federal Safety standards (Canadian and US)
BMCSS, FMVSS, and CMVSS.
Other applicable certification labels are affixed
to the component.
To Next Page
Loading...
Need help?
General
