Section 18: BODY
PA1593
9
4.2 Rear wheelhousing
(Entire braking system)
4.3 Rear wheelhousing
5.0 Close off wheelhousing using masking paper. Prevent rust inhibitor from coming in contact with paint.
To close off wheelhousing, a polythene sheet may be
used.
6.0 Apply TECTYL 185 GW black rust inhibitor onto
wheelhousing mechanical parts.
A spray gun and pumping system are required to apply
the rust inhibitor. If the application is done inside a paint
room, select high speed ventilation. Minimum required
thickness is 10 mils wet or 5 mils dry.
7.0 Remove all masking material 30 minutes after
application.
ANNEX 1
1. Check and confirm that dew point and surface temperature are in accordance with to the following
criteria:
Surface temperature > 10°C
Surface temperature > or = to dew point + 3°C
NOTE
Use the following table to determine dew point.
2. Check and confirm that TECTYL temperature is between 10°C and 35°C.
To Next Page