Section 18: BODY
PA1593
7
1.0 Wash both wheelhousing mechanical parts before
masking.
A water-hose nozzle is recommended. Water may be hot
to reduce washing time especially during winter. If parts
are soiled with oil, clean using R1KG21. Avoid rubber
parts.
2.0 Dry all water sprayed parts. Surface temperature and
dew point must be respected before applying rust
inhibitor.
Air pressure system may be used, refer to annex 1 for
surface temperature and dew point.
3.0 Front wheelhousing
a) Mask all rubber joints. Braking system must also be
protected (refer to arrows). Commercial aluminum foil
may be used for masking.
3.1 Front wheelhousing
Front view
3.2 Front wheelhousing
To Next Page