PREVOST X3-45 2016 - Page 340

Section 18: BODY
PA1593
26
 Discard waste according to applicable
environmental regulations, use dangerous
waste containers.
Electrical Power Window
 Insert 2 seals in the window frame.
 Apply some #680066 glue at the intersec-
tion of the 2 seals and also sparingly in
order to fix the seal to the window frame.
 Clean window using window cleaner.
 Insert window into frame.
 Secure window pane to raising
mechanism.
 Adjust window travel (6±3mm above
window wiper).
Driver’s Window Gutter
 Dry fit the gutter on the vehicle. If re-
quired, straighten up gutter using a ham-
mer and a wooden block.
 If applicable, remove plastic film at the
bottom of driver’s window.
 Remove excess of Sika underneath
driver’s window.
 Clean bottom of driver’s window using
window cleaner.
 Apply Sika Aktivator at the bottom of
driver’s window.
 Install gutter under driver’s window then
compress in order to fix double face self-
adhesive tape.
Strai
g
hten here
Straighten