Chapter 4 Coax/Twinax Emulation
138
PTX Transparent
Lead-in Char.
You can enable additional features that are not available in
standard Twinax emulations. To access these features, send text
commands in the data stream. The commands must have a start
and end code. Three sets (each containing a start and end code)
are available:
• Set 1. start code: <%
stop code: >
• Set 2. start code:¬¬
stop code: $
• Set 3. start code: _%
stop code: _
• Set 4. User Defined
User Defined
Select a hex value for the first and second start codes and the stop
code for the User Defined option.
Alt. Set 80-9F
• Printable. Prints data in the range of hex 80 through hex 9F.
• Control Code. Interprets data in the range of hex 80 through
hex 9F as a control code.
Graphic Chek Err
Allows overriding of the host setting for the SGEA (Set Graphic
Error Action) command. For more information about the SGEA
command, refer to the
Coax/Twinax Programmer’s Reference
Manual
.
• Enable. The host setting for the SGEA used by the printer. If
the SGEA command is requested to stop on graphic errors, the
printer will stop when a graphic error is detected.
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
To Next Page
Loading...
