Serial Submenu
207
Stop Bits
Sets the number of stop bits in the serial data word. Either one or
two stop bits can be selected. The setting must match the
corresponding stop bit setting in the host computer.
Parity
Set for odd parity, even parity, mark, sense, or no parity. The setting
must match the corresponding parity setting in the host computer.
Data Terminal Ready
This configuration is part of hardware flow control and determines
when the Data Terminal Ready (DTR) signal is generated. This
signal indicates if the printer is ready to receive data.
• True. Continuously asserts the DTR signal.
• On-Line and BNF (buffer not full). Asserts the DTR signal
when the printer is online and the internal serial buffer is not
full.
• Off-Line or BF (buffer full). Asserts the DTR signal when the
printer is offline or the internal serial buffer is full.
• On-Line. Asserts the DTR signal when the printer is online.
• False. Never asserts the DTR signal.
Request to Send
This configuration is part of hardware flow control and determines
when the Request to Send (RTS) signal is generated. This signal
indicates whether or not the printer is ready to receive data.
• On-Line and BNF. Asserts the RTS signal when the printer is
online and the internal serial buffer is not full.
• Off-Line or BF. Asserts the RTS signal when the printer is
offline or the internal serial buffer is full.
• On-Line. Asserts the RTS signal when the printer is online.
• False. Never asserts the RTS signal.
• True. Continuously asserts the RTS signal.
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
To Next Page
Loading...
