Printronix P5210 - Esc C Sequence; Received del; Private Mode

Menu
181
Character Set
This parameter selects a character set for the ANSI emulation.
Note that when 0876 OCR-A or 0877 OCR-B is selected as the
print language, the Font Attributes Typeface parameter is changed
to OCR-A or OCR-B, respectively. Character sets are shown in
detail in the
Character Sets Reference Manual .
Printer Select
• ON = DC1/OFF = DC3. Disables the printer when a DC1
control code is received, and enables the printer when a DC3
control code is received.
• Disable. Ignores the DC1 and DC3 control codes.
ESC c Sequence
• Enable. An ESC c code received from the host resets the
printer parameters to the factory defaults.
• Disable. An ESC c code received from the host is ignored.
Received CR
• Observe. A CR code received from the host is handled as a
Carriage Return.
• Ignore. A CR code received from the host is ignored.
Received DEL
• Observe. A DEL code received from the host is handled as a
Delete command.
• Ignore. A DEL code received from the host is ignored.
Private Mode
Determines the default type of character set (Set 1 or Set 2). This
can also be set by ESC sequences ESC [>5h and ESC [>5l. Refer
to these descriptions in the
ANSI Programmer’s Reference Manual
for further details.
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es