Printronix P7010 - Page 277

Fault Messages
277
HMR BANK FAN FLT Yes Sensors cannot detect
current in fan circuit.
Check that fan cable is connected.
Check for obstruction of vents and
fan airway; remove any
obstructions. Check for items
beneath the printer blocking cabinet
vents. Power back on the printer. If
this message recurs, contact your
authorized service representative.
1
ILL EXT BUS ACC* No Illegal External Bus
Access. Firmware error
on the controller board.
Contact your authorized service
representative.
1
ILL INST ACCSS* No Illegal Instruction
Accessed. Firmware
error on the controller
board.
Contact your authorized service
representative.
1
ILLGL OPR ACCSS* No Illegal Operand
Accessed. Firmware
error on controller board.
Contact your authorized service
representative.
1
INCOMPAT E-NET
Remove NIC
Yes Incompatible network
interface card (NIC) is
installed.
Install a compatible NIC to the
printer then reboot. If this message
still appears, contact your
authorized service representative.
1
INTAKE FAN FAULT Yes Sensors cannot detect
current in fan circuit.
Cycle power. If the message
appears, press CLEAR. If the
message does not clear, contact
your authorized service
representative.
1
INTERRUPT UNUSED
VECTOR 00
No The controller board
receives an interrupt it
does not understand. The
problem can be created
by electrical noise, by a
software problem, or by a
hardware problem.
Cycle power. If this message
occurred once and never again, you
can ignore it. If the message
reappears or appears consistently,
contact your authorized service
representative.
1
INVALID ACTIVATE No Printer detects a twinax
protocol communication
error.
Contact your authorized service
representative.
1
INVALID COMMAND No Printer detects a twinax
protocol communication
error and reports the
error.
Contact your authorized service
representative.
1
Table 15. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution