USER’S MANUAL. PRODIG-5
11/2006 Page 65
English
0 20 40 60 80 100 120
FRE
:
DL-Ku:
CH:
1300.02 MHz
MHz11900.0
2 MHz
» LEVEL:
C/N:
30.0
7.6
dBµV
dB
» POLARIZATION
» SAT BAND
» SEND
EXIT
» SATCR
VERTICAL
HIGH
POSITION A/B A
DiSEqC
Figure 40.- DiSEqC command screen.
Whenever a DiSEqC program is sent, the commands that correspond to the
equipment status in relation to the Horizontal or Vertical polarization and High or Low
frequency band are also sent. This allows assuring that the installation status is the one
indicated by the equipment.
5.19 SATCR function
By means of function SATCR it is possible to control the devices of a TV
installation satellite that are compatible with the SatCR
8
technology (Satellite Channel
Router), which allows to concentrate manifold down frequencys (slots) by an only cable.
By this way each user using a slot can tune and decode any signal present in the
satellite.
In order to select the SATRC function, press the DiSEqC key [21] from frontal
panel, and using the rotary selector [1] activate the SATRC option. In the display are
the configuration options that users can modify: slot selection, number of slots, device
address, Frequency sep, pilot signal activation, and finally the frequencies
corresponding to each slot.
0 20 40 60 80 100 120
FRE
:
DL-Ku:
CH:
1300.02 MHz
MHz11900.0
2 MHz
» LEVEL:
C/N:
30.0
7.6
dBµV
dB
SATCR
DiSEqC
» NUMBER OF SLOTS:
» ADDRESS:
» STEP:
» ENABLE PILOTS:
» SLOT 1:
» SLOT 2:
EXIT
» SELECTED SLOT:
2
0
1 MHz
OFF
950.05 MHz
1419.96 MHz
1
Figure 41.- SatCR command screen.
8
SatCR is a trademark of STMicroelectronics.
To Next Page
Loading...
Need help?
General
