USER’S MANUAL. PRODIG-5
11/2006 Page 35
English
After selecting the START field the instrument begins to carry out the available
measurements automatically. Once completed, the process will be ready to repeat
again (for example, for a new test point), or view measured data by turning the rotary
selector [1], or store the information in memory (SAVE) or exit from this acquisition
(EXIT).
5.10.1 DATALOGGER for Attenuation and IF SAT tests
The PRODIG-5
allows to make measurement acquisitions while executing an
Attenuation test at terrestrial band or an IF SAT test at satellite band
(see section
“5.11 Verification of distribution networks”).
For it, one of these tests should be activated previously as the following figure
shows.
FREQ:
REF:
TEST:
ATT:
10
0
-10
-20
48.30
90.6
86.3
4.3
519.25
83.7
73.1
10.6
631.25
83.6
70.2
13.4
MHz
dBuV
dBuV
dB
EXITCALIBRATE
Figure 12.- Attenuation Test. Terrestrial band.
In order to make the automatic acquisition of these measurements, select it from
UTILITIES menu by pressing the [22] key, and activating the RUN
DATALOGGER option, and later the NEW DATALOGGER option. In the CHANNEL
SET field will appear the type of test that the instrument is going to store automatically.
To Next Page
Loading...
Need help?
General
