GTR-3455
Doc Ref: Page: 13
Date: 13/01/13 Issue: H
Pr
seal
®
uk
Tray Sealing Solutions
2. INSTALLATION
2.1 Foundations
The foundation surface should be level, flat, and of sufficient strength and thickness to support the
weight of the machine.
2.2 Location
The machine should be located in a position that is free from draughts, from adjacent doors or
windows, which could adversely affect the sealing operation. The machine should be positioned
such that it does not cause a health and safety hazard due to its location.
Reasonable access must be left around all the sides of the machine for the changeover of sealing
tools and film reels.
2.3 Lifting and Positioning
WARNING: -
Always use suitably tested lifting gear with adequate lifting capacity for the weight of the machine.
Care must be taken, at the time of installation and during any subsequent removal, not to damage
or distort the turntable. The machine may be adjusted for height or for levelling using the adjustable
feet fitted.
When using forklift trucks, open front and rear doors, locate the forks with the forks spread wide
enough to clear guide rods as per diagram. Take care not to hit or damage any of the electrical
connections or guard switches. Please see drawing below for correct positioning.
Ensure the vehicle has adequate lifting capacity, and is fitted with suitable length forks or
extensions to support the machine.
To Next Page
Loading...