GTR-3455
Doc Ref: Page: 15
Date: 13/01/13 Issue: H
Pr
seal
®
uk
Tray Sealing Solutions
3. GTR MACHINE PRODUCTION RUNNING
WARNING: -
1. Nothing in these instructions should be assumed to supersede any operating or safety
procedures applicable at your own place of work.
2. Technically unqualified personnel should not attempt to open the control panel door or make any
unauthorised machine adjustments.
3.1 Start Up Procedure
WARNING: -
1. Before you start the machine ENSURE YOU KNOW HOW TO STOP IT!
2. Note the position of the emergency stop.
3. Opening the guard doors will also stop the machine in an emergency.
4. Take notice of all warning signs, including machine nip points and precautions during machine
operations.
1. Ensure the turntable is "clear" of any foreign objects, and that matching top tool and base tools
are fitted.
CAUTION: -
The machine must only be run with the correct top tool and matching base tool to avoid the cutting
blades, on a mismatched tool set, clashing with the base tool.
2. Switch mains isolator to the on “1” position.
NOTE: -
This puts power onto the heaters and should be switched on approximately 20 minutes before
production to ensure the correct tool temperature is reached.
3. Check the compressed air supply is switched on.
The air gauge on air supply set should read 5 to 6 Bar
4. Load film into the machine (as per instructions in section 3.4)
5. Ensure the seal, film feed and gas timers are set at the desired levels.
6. Place a product filled tray in the base tool.
7. Close all guards and press RESET to reset guard circuit.
8. Rotate table 180 degrees.
9. Sealed trays are raised for removal. Remove and replace with new trays.
10. Rotate table 180 degrees to repeat the operation and carry on with production.
To Next Page
Loading...