QNAP QGD-1602P - Drive Installation

3. Connect the power cord to the electrical outlet.
4. Power on the device.
Drive Installation
The QGD-1600P is compatible with 2.5-inch hard drives and 2.5-inch solid-state drives.
The QGD-1602P is compatible with 2.5-inch hard drives, 2.5-inch solid-state drives, and M.2 solid-state drives.
Installing 2.5-Inch Drives
The device is compatible with 2.5-inch hard disk drives and 2.5-inch solid-state drives.
Warning
• Installing a drive deletes all data on the drive.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
•
Moving fan blades: Keep your hands and other body parts away from moving fan
blades.
•
Other moving components: Keep your hands and other body parts away from other
moving components.
1. Power o the device.
2. Remove the case cover.
For details, see Removing the Case Cover.
3. Remove the drive module.
a. Remove the screws.
b.
Lift the drive module out of the device.
QGD Rackmount Switch User Guide
Installation and Conguration 20