Mirror Type Description
Transmit only Mirrors only outgoing packets to the destination port
Receive only Mirrors only incoming packets to the destination port
5. Select source ports.
Tip
You can select multiple source ports at the same time.
6. Select a destination port.
7. Click Apply.
QSS or QuNetSwitch saves the settings.
Enabling LLDP on the Switch
The Link Layer Discovery Protocol (LLDP) uses periodic broadcasts to advertise device information over the
network and discover neighboring devices. This protocol operates by establishing a distributed database
and gathering information from neighboring ports connected by a network link.
The LLDP page displays information about detected devices and allows you to enable and disable LLDP.
1. Log in to QSS, or open QuNetSwitch in QTS.
2. Go to Conguration > LLDP .
3. Change the LLDP control status.
Toggle Setting Description
The LLDP function is disabled
The LLDP function is enabled
4. Click Apply.
QSS or QuNetSwitch saves the setting.
Conguring Loop Protection
A loop occurs when data packets are continually forwarded between ports. If a loop is detected, loop
protection can disable the interface.
1. Log in to QSS, or open QuNetSwitch in QTS.
2. Go to Conguration > Loop Protection .
3.
Next to Loop Protection, click .
Loop protection is enabled.
4. Congure the settings.
QGD Rackmount Switch User Guide
Switch Management 69
To Next Page
Loading...
Need help?
General
