QNAP QGD-1602P - Deleting a Network Setting; Monitoring Network Settings

Setting Description
Transmission time Controls the time between transmitted loop protection packets
Note
• The default transmission time is 5 seconds.
• The value must be from 1 to 10 seconds.
Shutdown time Controls how long to disable a port after detecting a loop
Note
• The default shutdown time is 180 seconds.
• The value must be from 0 to 604800 seconds.
5. Click Apply.
QSS or QuNetSwitch saves the settings.
Deleting a Network Setting
1. Log in to QSS, or open QuNetSwitch in QTS.
2. Go to Conguration.
3. Select a network setting.
Note
Deleting network settings is applicable only to link aggregation groups, static MAC addresses,
and VLANs.
4.
Click .
A conrmation message appears.
5. Click Delete.
Monitoring Network Settings
You can monitor the following network settings in the Conguration section. These settings can be used to
monitor and diagnose switch operations.
1. Log in to QSS, or open QuNetSwitch in QTS.
2. Go to Conguration.
3. Select a network setting.
Setting Description
IGMP Snooping
Statistics
Go to IGMP > IGMP Snooping Statistics .
Displays statistical information about detected IGMP groups.
LLP Remote Devices Go to LLDP > LLDP Remote Devices .
Displays information about the LLDP-enabled port including system
capabilities and remote management IP address.
QGD Rackmount Switch User Guide
Switch Management 70