QuadTech Guardian 2500 Series - Page 22

Page 22 of 22
Condensed Operating Instructions (continued)
Press PROGRAM key
to enter program mode
Press arrow to
change the first
parameter (changed to
AC Real Current)
Press arrow to
program next parameter
Press arrow to
change the first
parameter (changed to
1.000KV)
Press arrow to
continue programming
parameters and arrows
to make changes
Display returns to Idle mode after programming the last parameter.
or
Press arrow to reverse the selection of parameters
or
Exit Program mode at any time by (with changes made) by pressing
PROGRAM key
3. Return the display to Idle mode (upper right) and the test # desired (upper left) before
proceeding.
1 Program
??????????
1 Program
Volt: 1.000KV
1 Program
Volt: 0.500KV
1 Program
Mode: AC Real Current
1 Program
Mode: AC Total Current
1 AC:0.500KV Program
Hi:15.00mA 7.0sec