QuadTech Guardian 2500 Series User Manual

Page 48 of 48 Operation/Programming
3. To Program Sequence Test #3
Press right arrow key and to program a test number for step 3 of the sequence.
Press up/down arrow keys to select the third test in the sequence as none, ship, 1 –25 or
calc (see discussion of the calculate function, step 4 below).
Press right arrow key to exit the program mode and display the complete sequence for
sequence test number 1. “Program” message now indicates “Idle” and the three tests which
were programmed to make up the sequence are now indicated.
S1 Idle
Tests: 1`: 2: 3
S1: 3 Program
Tests: none
S1: 3 Program
Tests: none
S1: 3 Program
Tests: skip
S1: 3 Program
Tests: calc
S1: 3 Program
Tests: 3

QuadTech Guardian 2500 Series Specifications

General

Brand	QuadTech
Model	Guardian 2500 Series
Category	Test Equipment
Language	English