Operation/Programming Page 55 of 55
2.4.7 RS-232 Interface
The Guardian 2500 allows operator selection of the baud rate for the RS-232 (interface standard
with unit).
1. Press the UTILITY key and right arrow key to select the RS-232 Interface function.
2. Press up/down arrow keys to select 9600 or 19200 or Disable.
NOTE
When the RS-232 is set to Disable with no IEEE-488 interface option present the following
message will be displayed:
CONFIG REMOTE
HARDWARE NOT DETECTED
When the RS-232 is set to Disable with the IEEE-488 interface option present this port is
functional, refer to paragraph 2.4.8 for available IEEE address selections.
2.4.8 IEEE-488 Interface (Optional)
The Guardian 2500 allows operator selection of IEEE-488 address of 1 through 16 (when this
option is included).
1. Press the UTILITY key and right arrow key to select IEEE Address.
2. Press up/down arrow keys to select 1 through 16.
NOTE
The RS232 interface must be set to
Disable for the IEEE-488 interface
to function.
To Next Page
Loading...