Operation/Programming Page 49 of 49
4. Programming the Calculate Measurement Function
If calc is selected for test #2 or #3, as described above, press right arrow, then the
up/down arrow key to select the current parameter to be calculated, AC Total, AC Real
or AC Imaginary.
Press the right arrow key to select the entry of the calculated High Limit, and then the
up/down arrow key to increase or decrease the limit between 0.001mA and 15.000mA.
Press the right arrow key to select the entry of the calculated Low Limit, and then the
up/down arrow key to increase or decrease the limit between 0.001mA and 15.000mA.
The low limit must be set to less than the high limit.
To Next Page
Loading...
Need help?
General
