QuadTech Guardian 2500 Series User Manual

Page 21 of 21
Condensed Operating Instructions (continued)
Return the display to Idle mode (upper right) and the test # desired (upper left) before
proceeding.
Table of Programmable Test Conditions
For the Guardian Models 2510, 2520, 2530
Programmable
Parameters
2510
2520
2530
AC
2520
2530
DC
2530
IR
Mode
X
X
X
Voltage
X
X
X
Hi Limit
X
X
X
Lo Limit
X
X
X
Arc Limit
X
X
Ramp Time
X
X
X
Hi Limit Ramp
X
X
X
Lo Limit Ramp
X
X
X
Dwell Time
X
X
Test Time
X
X
X
Fall Time
X
X
X
Frequency
X
Gnd Continuity
X
X
X
Modifying/Programming Test Conditions
1. Press the TEST NUMBER key to sequence up through the test setups, selecting one for
change or one not presently programmed, as noted by the message “No Test Programmed”.
Continue to press the key repeatedly to select any setup desired (user test 1-25, or sequence
S1-S9). Typical display below shows setup #1 programmed for AC Hipot at 500 volts, high
current limit of 15 mA and test time of 7 seconds. Note the message “Idle” in the upper right
display, this area always indicates the instrument status. (Pressing the up/down arrow
key will also sequence through the test setups, up or down)
2. Once the desired test # has been selected (remains displayed), to change test conditions
proceed as follows:
1 AC:0.500KV Idle
Hi:15.00mA 7.0sec

QuadTech Guardian 2500 Series Specifications

General

Brand	QuadTech
Model	Guardian 2500 Series
Category	Test Equipment
Language	English