Page 58 of 58 Operation/Programming
3. Continue Voltage On Fail
This selection determines whether to continuously repeat the same test on fail. When On is
selected, if a test fails the voltage remains activated and the same measurement will be repeated
again and can be repeated indefinitely. When turned on, this mode is generally used as a
continuous probing mode of operation.
Press the UTILITY key and right arrow key to select Enhanced Features.
If Enhanced Features is set for On, press right arrow key to select Cont Volt On Fail.
If Enhanced Features is set for Off, press up/down arrow key to select On and
press right arrow key to select Cont Volt On Fail.
Press up/down arrow keys to select Continuous Voltage on Fail, On or Off.
Press the UTILITY key to exit or move to other Enhanced Features with the right
arrow key.
4. Continue Steps On Fail
This selection determines if the unit will stop testing or proceed to the next test on fail during a
sequence test. When On is selected, if a test fails the instrument proceeds to the next test in the
sequence. This feature only applies to sequence test setups (S1 through S9).
Press the UTILITY key and right arrow key to select Enhanced Features.
If Enhanced Features is set for On, press right arrow key to select Cont Steps On Fail.
If Enhanced Features is set for Off, press up/down arrow key to select On and
press right arrow key to select Cont Steps On Fail.
Press up/down arrow keys to select Continue Steps on Fail, On or Off.
To Next Page
Loading...
Need help?
General
