Operation/Programming Page 59 of 59
Press the UTILITY key to exit or move to other Enhanced Features with the right
arrow key.
5. Stop Test On Pass
This selection determines if the unit will stop testing during an insulation resistance (IR)
measurement once the value exceeds the low limit, which would meet the requirements for a
Pass. This feature only applicable in IR mode.
Press the UTILITY key and right arrow key to select Enhanced Features.
If Enhanced Features is set for On, press right arrow key to select Stop Test On Pass.
If Enhanced Features is set for Off, press up/down arrow key to select On and
Press right arrow key to select Stop Test On Pass.
Press up/down arrow keys to select Stop Test On Pass, On or Off
Press the UTILITY key to exit or move to other Enhanced Features with the right
arrow key.
To Next Page
Loading...