Contents (continued)
2.3 Programming Sequence Tests........................................................................46
1. Sequence Test #1 .......................................................................................46
2. Sequence Test #2 .......................................................................................47
3. Sequence Test #3 .......................................................................................48
4. Calculate Measurement Function ..............................................................49
2.4 Utility Functions ............................................................................................50
2.4.1 General...............................................................................................50
2.4.2 Measure Offset...................................................................................51
2.4.3 Keypad Lockout.................................................................................51
2.4.4 Test Location .....................................................................................53
2.4.5 Buzzer On Fail ...................................................................................54
2.4.6 Beep On Key Hit................................................................................55
2.4.7 RS-232 Interface (Optional) ..............................................................55
2.4.8 IEEE-488 Interface (Optional)...........................................................55
2.4.9 Enhanced Features .............................................................................56
1. Test Low Limit ..............................................................................56
2. Delay Time.....................................................................................57
3. Continue Voltage On Fail ..............................................................58
4. Continue Steps On Fail ..................................................................58
5. Stop Test On Pass ..........................................................................59
6. Step And Increment .......................................................................60
7. Clear All Tests ...............................................................................60
8. Test To View..................................................................................62
9. Perform Calibration .......................................................................62
10. Ground Fault Stop........................................................................63
11. Arc pulse Width .......................................................................................64
12. Adaptive DC Ramp......................................................................64
13. Autoranging .................................................................................65
2.5 Default Test Conditions .................................................................................67
2.5.1 General...............................................................................................67
2.5.2 Setups.................................................................................................67
2.6 Error Messages...............................................................................................68
To Next Page
Loading...
Need help?
General
