This command for CLI will configured the mode of load balance on the specific Port Channel. The
parameter ā
src-mac | dst-mac | dst-src-mac | src-ip | dst-ip | dst-src-ip |
enhancedā represent the
mode used to be set for port-channel load balance.
Syntax
load-balance { src-mac | dst-mac | dst-src-mac | src-ip | dst-ip | dst-src-ip | enhanced }
no load-balance
src-mac - Sets the mode on the source MAC address.
dst-mac - Sets the mode on the destination MAC address.
dst-src-mac - Sets the mode on the source and destination MAC addresses.
src-ip - Sets the mode on the source IP address.
dst-ip - Sets the mode on the destination IP address.
dst-src-ip - Sets the mode on the source and destination IP addresses.
enhanced - Set the mode on the source and destination MAC addresses if it is a L2 packet or on the
source and destination IP addresses if it is a IP packet.
no - Restore the mode to be default value.
Default Setting
dst-src-ip
Command Mode
Interface Config
To Next Page
Loading...