Quanta Computer QuantaMesh - Page 234

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
234
show trapflags
Default Setting
None
Command Mode
Privileged Exec
Display Message
Authentication Flag: May be enabled or disabled. The factory default is enabled. Indicates whether
authentication failure traps will be sent.
Link Up/Down Flag: May be enabled or disabled. The factory default is enabled. Indicates whether
link status traps will be sent.
Multiple Users Flag: May be enabled or disabled. The factory default is enabled. Indicates whether
a trap will be sent when the same user ID is logged into the switch more than once at the same time
(either via telnet or serial port).
Spanning Tree Flag: May be enabled or disabled. The factory default is enabled. Indicates whether
spanning tree traps will be sent.
ACL Traps: May be enabled or disabled. The factory default is disabled. Indicates whether ACL
traps will be sent.
BGP Traps: May be enabled or disabled. The factory default is disabled. Indicates whether BGP
traps will be sent.
DVMRP Traps: May be enabled or disabled. The factory default is disabled. Indicates whether
DVMRP traps will be sent.
OSPFv2 Traps: May be enabled or disabled. The factory default is disabled. Indicates whether
OSPF traps will be sent.
PIM Traps: May be enabled or disabled. The factory default is disabled. Indicates whether PIM traps
will be sent.
Transceiver Traps: May be enabled or disabled. The factory default is disabled. Indicates whether
Transceiver traps will be sent.