Quanta Computer QuantaMesh - Page 235

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
235
5.3.6.3 snmp trap link-status
5.3.6.3.1 snmptrap link-status
This command enables link status traps by interface.
This command is valid only when the Link Up/Down Flag is enabled. See ‘snmpserver
enable traps linkmode’ command.
Syntax
snmptrap link-status
no snmptrap link-status
no - This command disables link status traps by interface.
Default Setting
Disabled
Command Mode
Interface Config
5.3.6.3.2 snmptrap link-status all
This command enables link status traps for all interfaces.
This command is valid only when the Link Up/Down Flag is enabled. See ‘snmpserver
enable traps linkmode’ command.
Syntax
snmp trap link-status all
no snmp trap link-status all
all - All interfaces.
no - This command disables link status traps for all interfaces.
Default Setting
Disabled
Command Mode
Global Config
i
i