Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
To configure the TCP port to use for communication with the SMTP server. The recommended port for
TLSv1 is 465, STARTTLS is 587 and for no security (i.e. none) it is 25. However, any nonstandard port
in the range 1 to 65535 is also allowed.
Syntax
port <1-65535>
<1-65535> - Specify the TCP port number to be used to send the email log messages. Generally,
security protocol TLSv1 uses 465, STARTTLS uses 587 and no security uses 25.
no - This command resets the TCP port to the default value of the current configured security
protocol.
Default Setting
25
Command Mode
Mail-Server Config
This command is used to configure the loging ID the switch uses to authenticate with the SMTP server.
Syntax
username <username>
<username> - Mail server username configuration. The length of username could be 1 to 32
characters.
no - This command resets the username to the default value. The default username is admin.
Default Setting
admin
Command Mode
Mail-Server Config
To Next Page
Loading...