Quanta Computer QuantaMesh - Page 433

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
433
5.12.1.14 show lldp tlv-select
The user can go to the CLI Privilege Exec to d display the DCBX TLV configuration of an interface on the
system, use the show lldp tlv-select interface [<slot/port>] Privilege command.
Syntax
show lldp tlv-select interface [<slot/port>]
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface: Specifies all the ports on which DCBX TLV can be configured.
ETS Config: Specifies the DCBX ets-configuration TLV status of the interfaces.
ETS Recommend: Specifies the DCBX DCBX ets-recommendation TLV on the interfaces.
PFC: Specifies the DCBX priority flow control TLV on the interfaces.
App priority: Specifies the DCBX application-priority TLV on the interfaces.
5.12.1.15 show lldp remote-comparison
The user can go to the CLI Privilege Exec to d display LLDP comparison between remote & local
interface on the system, use the show lldp remote-comparison [<slot/port>] Privilege command.
Syntax
show lldp remote-comparison [<slot/port>]
Default Setting
None
Command Mode
Privileged Exec
Display Message
LLDP Comparison: Specifies all the difference of TLVs between remote interface & local interface.