Quanta Computer QuantaMesh - Page 444

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
444
Default Setting
auto
Command Mode
Global Config
5.12.2.17 lldp dcbx port-role
The user can go to the CLI Interface Configuration Mode to configure DCBX auto configuration port role
by using the lldp dcbx port-role Interface configuration command. Use the no lldp dcbx port-role to
reset this function to default.
Syntax
lldp dcbx port-role <auto-down | auto-up | configuration-source | manual>
no lldp dcbx port-role
auto-down - Configure interface as auto-down stream.
auto-up - Configure interface as auto-up stream.
configuration-source - Configure interface as configuration source.
manual - Configure interface as manual port.
Default Setting
manual
Command Mode
Interface Config