Quanta Computer QuantaMesh - Page 445

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
445
5.12.2.18 lldp tlv-select
This command is used to configure lldp to transmit-tlv DCBX TLV(s). Use the no lldp tlv-select to
disable this function.
Syntax
lldp tlv-select dcbxp [application-priority | ets-config | ets-recommend | pfc]
no lldp tlv-select dcbxp
application-priority - Include DCBX application-priority TLV.
ets-config - Include DCBX ets-configuration TLV.
ets-recommend - Include DCBX ets-recommendation TLV.
pfc - Include DCBX priority flow control TLV.
Default Setting
manual
Command Mode
Interface Config, Global Config