5.28.2.3 mlag system-mac
This command manually configures the Multi-chassis Link Aggregation (MLAG) domain MAC address.
To restore the default system MAC address, use the no form of this command.
Syntax
mlag system-mac <mac-address>
no mlag system-mac
<mac-address> - Syatem MAC adress.
Default Setting
None
Command Mode
Global Config
5.28.2.4 mlag peer-link
This command creates a Multi-chassis Link Aggregation (MLAG) peer link by designating the port
channel that you want on each device as the peer link for the specified MLAG domain.
To remove the peer link, use the no form of this command.
Syntax
mlag peer-link
no mlag peer-link
Default Setting
Disabled
Command Mode
Interface Config
To Next Page
Loading...