5.28.2.5 mlag <mlag-number>
This command moves other port channels into a Multi-chassis Link Aggregation (MLAG) to connect to
the downstream device. The range is from 1 and 4096.
To remove the port channels from the mlag, use the no form of this command.
Syntax
mlag <mlag-number>
no mlag
<mlag-number> - Domain identify number of MLAG port-channel member (Range: 1 – 4096).
Default Setting
Disabled
Command Mode
Interface Config
5.28.2.6 mlag peer-gateway
This command enable Layer 3 forwarding for packets destined to the gateway MAC address of the
MLAG. Use no form to disable it.
Syntax
mlag peer-gateway
no mlag peer-gateway
no – This command disable the peer-gateway.
Default Setting
Enabled
Command Mode
Global Config
To Next Page
Loading...